Rockwell Tools 1783-MS10T User Manual download pdf (Page 67)

Publication 1783-UM002C-EN-P - April 2009 67

Chapter 2

Connect to SFP Modules

This section describes how to connect to a fiber-optic SFP port. To connect to

an RJ45 Gigabit Ethernet port instead of a fiber-optic port, see the Connect to

the Switch Ports section on page 58.

Follow these steps to connect a fiber-optic cable to an SFP module:

1. Remove the rubber plugs from the module port and fiber-optic cable,

and store them for future use.

2. Insert one end of the fiber-optic cable into the SFP module port.

3. Insert the other cable end into a fiber-optic receptacle on a target device.

WARNING

Do not remove the rubber plugs from the SFP module port or the

rubber caps from the fiber-optic cable until you are ready to

connect the cable. The plugs and caps protect the SFP module

ports and cables from contamination and ambient light.

See Chapter 4

for information about the LC on the SFP module.

.



LC Connector

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 91 92

No comments

Rockwell Tools 1783-MS10T User Manual Page 67