Rockwell Tools 1783-MS10T User Manual download pdf (Page 12)

12 Publication 1783-UM002C-EN-P - April 2009

Chapter 1

See the Stratix 8000 Ethernet Managed Switches Software User Manual,

publication 1783-UM003A, for more information on alarm configuration..

For more information about the power and relay connector, see Chapter 4,

Cable and Connectors.

Console Port

For configuring, monitoring, and managing the switch, you can connect a

switch to a computer through the console port and the supplied RJ45-to-DB-9

adapter cable. If you want to connect a switch to a terminal, you need to

provide an RJ45-to-DB-25 female DTE adapter. For console-port and

adapter-pinout information, see the Two Twisted-pair Straight-through Cable

Schematic on page 76.

Dual-Purpose Uplink Ports

The two dual-purpose uplink ports may each be configured for RJ45 (copper)

or SFP (fiber) media types. Only one of these connections in each of the

dual-purpose ports can be active at a time. If both ports are connected, the

SFP module port has priority.

You can set the copper RJ45 ports to operate at 10, 100, or 1000 Mb/s in

full-duplex or half-duplex mode. You can configure them as fixed 10, 100, or

1000 Mb/s (Gigabit) Ethernet ports and can configure the duplex setting.

You can use approved Gigabit (or 100 Mbps) Ethernet SFP modules to

establish fiber-optic connections to other switches. These transceiver modules

are field-replaceable, providing the uplink interfaces when inserted in an SFP

module slot. You use fiber-optic cables with LC connectors to connect to a

fiber-optic SFP module. These ports operate in the full duplex mode only.

WARNING

If you connect or disconnect the console cable with power

applied to the switch or any device on the network, an electrical

arc can occur. This could cause an explosion in hazardous

location installations. Be sure that power is removed or the

area is nonhazardous before proceeding.

To verify switch operation, perform POST on the switch in a

nonhazardous location before installation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 91 92

No comments

Rockwell Tools 1783-MS10T User Manual Page 12